Multi-Layer Ceramic Fiber Lining Design: Stop Thermal Bridges
Multi-Layer Ceramic Fiber Lining Design: Stop Thermal Bridges
When designing a furnace lining for extreme temperatures, a single layer of ceramic fiber board is rarely sufficient. To achieve the required thermal resistance and keep the steel shell at a safe operating temperature, engineers must use a multi-layer design. However, simply stacking boards is not enough—how you arrange the joints is critical.
The Danger of Aligned Joints
If the joints of the hot face layer align perfectly with the joints of the back-up layer, you create a direct path for heat to escape. This is known as a thermal bridge. Because ceramic fiber materials experience slight thermal shrinkage at high temperatures, these aligned gaps will eventually widen, allowing hot gases to penetrate and overheat the furnace casing.
The Solution: Staggered Joints
To eliminate thermal bridges, furnace designers must specify staggered joints. By offsetting the boards in the second layer, any heat that penetrates the first layer is forced to travel laterally, significantly reducing heat loss.
To make this work, the dimensions of the boards must be highly accurate. Our high-density pressed boards are machined to tight tolerances, ensuring the joints fit tightly together to maximize the efficiency of the multi-layer design.
Optimizing the Back-Up Layer
For the hot face, high-purity alumina or mullite boards are used to resist extreme heat and erosion. For the back-up layer, standard high-alumina boards or ceramic fiber blankets can be utilized to optimize cost without compromising the overall thermal resistance. Pre-fired ceramic fiber boards are highly recommended for the hot face to prevent initial shrinkage from opening up the staggered joints.


